#986-301 Rear Driveshaft Prop Shift For 2010-2016 Cadillac SRX All Wheel Drive

  

Drive Shaft Length(IN): 93.701. Drive Shaft Wall Thickness(IN): 0.079. Shaft Diameter(IN): 2.874/2.874/2.007.

22885388, 20927516, 22822140, 20870868, 20896295, 20930099, 20979553, 651005, 986-301. Built to strict quality control standards 100% factory tested. This drive shaft is made to the original equipment dimensions for dependable fit and performance. This drive shaft is made of high-strength steel, with polished and has anti-rust protection to ensure its long-lasting use, durable in the strength and efficiency in the performance. This drive shaft can reduce vehicle vibration and noise, and improve driving comfort.

Keep the driveshaft dry: Before installation, ensure that the driveshaft is dry, otherwise water and moisture can cause corrosion and rust on the driveshaft. Adjusting the length of the driveshaft: Adjust the length of the driveshaft according to the vehicle's track width and the distance between the front and rear axles, so that it can fit the vehicle properly. Avoid impact when installing the driveshaft: When installing the driveshaft, avoid forceful tapping or impact on the driveshaft to avoid damaging parts. Inspection and installation: After installation is completed, it is necessary to check whether the driveshaft is installed correctly, and whether there are problems such as oil leakage and looseness. Pay attention to the maintenance of the driveshaft: During use, it is necessary to regularly check the wear and damage of the driveshaft, and replace parts or repair them in a timely manner.

Reasonable load bearing: When loading goods, it is necessary to load the vehicle according to its load capacity and avoid overloading to avoid damage to the driveshaft due to excessive load. Pay attention to vibration during driving: Pay attention to the vibration of the driveshaft during driving. If excessive vibration is found, stop the vehicle immediately for inspection? The driveshaft is an important component of the vehicle's drivetrain system. Common problems with the driveshaft include the following. Vibration and noise: The driveshaft may vibrate or produce noise when the vehicle is driven at high speeds. This may be caused by an unbalanced driveshaft or worn bearings. Troubleshooting measures: Check the balance of the driveshaft and perform balancing if necessary.

Check the bearings for wear and replace them if necessary. Oil leaks: The driveshaft may develop oil leaks over time due to worn or damaged seals. Troubleshooting measures: Replace the seals.

Breakage: The driveshaft may break due to excessive wear or overload. Troubleshooting measures: Replace the driveshaft. Bending: The driveshaft may become bent due to collision or excessive load. Speed mismatch: The driveshaft may cause speed mismatch due to incorrect length or improper installation. Troubleshooting measures: Check the length of the driveshaft and reinstall it properly.

We will work hard to make sure every customer 100 percent satisfied, and resolve any problem for you. Catalytic Converter for 2002 2003 2004 2005 Chevrolet Trailblazer 4.2L 55476.

Catalytic Converter for Chevrolet Cobalt 2005 2006 2007 Pontiac L4 2.2L. Catalytic Converter set For Infiniti EX35 FX35 G35 G37 M35 M37 Nissan 350z 370z.